vistasoli.blogg.se - Raid monitor proccess

Raid monitor proccess install#
Raid monitor proccess driver#
Raid monitor proccess password#

Reboot the ESXi after installing the LSI Provider.Īfter rebooting the ESXi, you need to change the client host file:.

Raid monitor proccess install#

Enter the esxcli software vib install -v / LSI_bootbank_lsiprovider_xxx.xx.Vx.62-xxxx.vib -force -maintenance-mode command to install the LSI Provider on ESXi.Use the ls command to show the contents of the root directory in ESXi.

Raid monitor proccess password#

The password of the server is required during the transference. Transfer the LSI Provider.vib file on client to the server using the pscp.exe LSI_bootbank_lsiprovider_xxx.xx.Vx.62-xxxx.vib command, where root is the logon user name of the ESXi server and 192.168.1.200 is the ESXi server IP.Access the Windows Virtual Machine where Intel® RAID Web Console 2 was installed and mount the USB flash drive, open the Windows Command Prompt, and change to the directory of the USB flash drive. Copy both pscp.exe and LSI_bootbank_lsiprovider_xxx.xx.Vx.62-xxxx.vib into the root of an empty USB flash drive.vib file version) is needed shortly.ĭownload pscp.exe from the Download PuTTY page. The LSI_bootbank_lsiprovider_xxx.xx.Vx.62-xxxx.vib (the x is actually a number that varies depending on the. Next, download and install the SMI-S Provider on the ESXi machine.Īfter you have downloaded the file, unzip it and open the vib20/lsiprovider path.

Raid monitor proccess driver#

You can find the VMWare driver for your Intel® RAID Controller from VMWare.

The default status of the ESXi SSH is disabled as is shown in the figure below:Īfter you verify that the requirements mentioned above are met, download and install RWC2 on the remote Windows* machine that you will use to monitor the RAID.

The default status of the ESXi Shell is disabled as is shown in the figure below:.

Press key to save the changes.Īfter you change the hostname, you need to enable to ESXi Shell and ESXi SSH:

Press key to exit the DNS configuration.

Scroll the arrow to Hostname, and then enter the new hostname.

Press key to the DNS configuration screen. Current DNS configuration information is displayed on the right side of the screen.

Scroll the arrow to DNS configuration.

Press key to enter the network management configuration. The current hostname and IP address are displayed on the right side of the screen.

Scroll the arrows to Configure Management Network.

Press to enter the Customize System/View Logs.

If the hostname of your machine is already different, make sure to write it down as you are going to need it later on. Verify that the hostname is not localhost.

While most of the information and steps described in this article applies to RWC3, you can also refer to the RWC3 installation guide for details.Ĭonsidering that ESXi is already installed and in production, proceed as outlined below: Intel® RAID Web Console 2 is end-of-life and replaced by Intel RAID Web Console 3 (RWC3). You can install Intel RWC2 on a remote or virtual machine running Windows or Linux. You can use the Intel RAID Web Console 2 (RWC2) to monitor a RAID array on a VMWare ESXi server, however, it cannot be installed on ESXi directly. VMware ESXi (5.0, 5.5, 6.0, 6.5) already installed and in production.

I'm unable to monitor a RAID array from a Windows Virtual Machine running in a VMware ESXi* server.